Operation:

Note: the machine should be tightly connected with the ground .

1.Get ready of the power, and press the power button ,then the power indicator is lightened .

2.Adjust the temperature to right range. when the temperature reaches the right degree, the indicator on the top of temperature-adjuster switch off . then the following operations can be conducted.

3.Adjust time –controller to right time .

4.Take hold of handle and rightwards the heat board.

5.Flately place the cloth on the platen , then cover the printing paper (please note the right surface of the paper)push the handle down to specified point .please note that the force should be no more than 25kg at this time , otherwise ,the handle will be transformed.

6.When the printing time is over, the buzzer noise ,then lift the handle to where it was.

7.If you want to peel a cooled printing paper,you should brush the paper ,then let it alone for 5-10 seconds before peel the paper .if you want to peel the hot printing paper, you can do it immediately after printing .successful print requires right time ,temperature and pressure .the thickness and material of the clothes ,even the type of printing paper affect the performance of print.( please ask your supplier about related information of the printing paper)

Maintenance:

1.Pressure: if the pressure is not enough or too much, you can tune the pressure-adjuster. raise the pressure by turning the knob in clockwise and lower it in counter-clockwise.

2.Time: if the temperature has reached specified value, but the buzzer does not noise or always noise and never stop, you should adjust it to right place .

3.Temperature: if the temperature up to the specified degree, the meter will points to 180℃ (within 5 minutes). If the reading meter raise but the heating platen is not heated, please check the electric circuits.

4.When the handle pushed down, but it lifted up automatically.  Please adjust the knob down.

5.After the print is completed, the handle is hard to lift up, you may adjust the knob up.